•
Load GWBASIC
•
Load and then run the program TC847.BAS
•
Set the Baud Rate on the Controller of the 9112A to 9600
•
Set the address of your furnace to 10 or greater
•
Set the temperature or if needed the furnace parameters. A listing of the
parameters and their meaning are in the following table.
To set a parameter, simply type in the parameter and the value. For example, to
set the control temperature to 800°C, type SL=800.
9112A Calibration Furnace
User’s Guide
26
PV
process value (temperature)
SL
set-point
OP
output power
XP
proportional band
TI
integration time
TD
derivative time
CH
Cycle time
Table 2.
Command Parameters
