Fluke 522A/6, Operator'S Manual

Page: 348 / 426

5522A
Operators Manual
10-34
Parameters: 1 to 60 (seconds)
Example:
TLIMIT 30
TLIMIT?
(IEEE-488, RS-232, Sequential)
Returns the programmed OPERATE time limit for the OVERLD mode signal.
Response: <Integer>
Time limit in seconds.
TLIMIT_D
(IEEE-488, RS-232, Sequential)
Sets the default OPERATE time limit for the OVERLD mode signal.
Parameters: 1 to 60 (seconds)
Example:
TLIMIT_D 15
TLIMIT_D?
(IEEE-488, RS-232, Sequential)
Returns the default overload time limit.
Response: <Integer> Default time limit in seconds.
Impedance/Capacitance Function Commands
ZERO_MEAS
(IEEE-488, RS-232, Sequential)
Sets the measurement offset to the capacitance value.
Parameters: (boolean)
ON
or
OFF
.
*TRG
(IEEE-488, RS-232, Sequential)
Triggers and returns a new impedance measurement value when used with the SC1100
option in MEAS Z mode. (See Chapter 6 for *TRG use in all cases except MEAS Z mode
with the SC1100 option.)
Responses: <measurement value>,
OHM
(input impedance value in ohms)
<measurement value>,
F
(input capacitance value in farads)
<measurement value>,
NONE
(no measurement is available)
Example:
*TRG
returns
1.00E+03,OHM
(1 k
Ω
input impedance).
Note
You can also use the VAL? query to return an impedance measurement
value with the SC1100 option. VAL? returns the last measurement, whereas
*TRG gets a new measurement. Responses are the same as shown above for
the *TRG command. (See Chapter 6 for VAL? use with thermocouple
measurements.)