ENTER THE NUMBER TO PRINT
PRINT N: 1
A message appears requesting you to press
ENTER
to begin printing. Press
ENTER
to continue or
EXIT
to abort. As the measurements are printed, a
message window appears to indicate that printing is in process. You can cancel
the operation at any time by pressing
EXIT
.
The last PRINT N number of measurements stored in memory will be printed
to the selected output device. If the number of measurements available is less
than the PRINT N number, only the available measurements will be printed.
Printing the measurements from memory does not affect the data stored in
memory. Each measurement is printed with the channel number, measurement
value, unit prefix, unit, time (in 24-hour format), and date. Use the
SET UP
DEVICE
soft-key function (see Section 5.4.2) to configure printer port options
such as baud rate or linefeed enable.
5.3.5
Clear Statistics
The
CLEAR STATS
soft-key clears the statistical registers and resets all statis-
tical calculations. Refer to Sections 5.3.1.1 and 5.3.1.2 to display statistical
data. A message appears briefly at the bottom of the screen indicating the stats
have been cleared.
5.4
Module Menu
The
MODULE
menu provides functions for setting module operating condi-
tions, executing functions built in to the modules, setting module calibration
parameters, executing module calibration routines, and viewing information re-
lating to the modules. The soft-key functions that appear in this menu are
SET
UP SCREEN
,
SET UP DEVICE
,
CAL DEVICE
, and
MODULE INFO
.
5.4.1
Set Up Screen
The
SET UP SCREEN
soft-key function is used to set physical parameters re-
lating to the screen such as brightness and screen saver.
53
5 Soft-Key Functions
Module Menu
