Fluke Calibration RUSKA 7615, User Manual

Page: 23 / 64

3-1
Chapter 3
Installation
Introduction
This portion of the manual discusses initial installation for the RUSKA 7615 Calibrator.
Installing the Calibrator is a relatively simple process of unpacking the Calibrator,
powering it up, and then using the front panel to configure the system.
Unpacking the Calibrator
Carefully unpack all components, checking for obvious signs of damage. In addition to
any nonstandard items ordered with the Calibrator, the shipment should contain at least
the following items:
•
RUSKA 7615 Calibrator
•
power cord, and this user’s manual
If necessary, report any shipping damage to the freight agency. Remove masking tape,
strings, and packing materials from all components. If possible, save the packing
materials for future use.
Finally, install the Calibrator in a location that meets the requirements listed in Table 3-1.
Note
The Calibrator should not be subjected to mechanical shocks during
installation or use. It should be mounted on a rigid bench or in a sturdy
19 inch rack.