Fluke Calibration RUSKA 7615, User Manual

Page: 13 / 64

General Information
Symbols Used in this Manual
1
1-3
W
Warning
If the equipment is used in a manner not specified by the
manufacturer, the protection provided by the equipment may be
impaired. The AC main plug, switch and power cord shall
remain readily accessible for operation.
Symbols Used in this Manual
In this manual, a Warning identifies conditions and actions that pose a hazard to the user.
A Caution identifies conditions and actions that may damage the Calibrator.
Symbols used on the Hydraulic Pressure Controller/Calibrator (Calibrator) and in this
manual are explained in Table 1-1.
Table 1-1. Symbols
Symbol Description
B
AC (Alternating Current)
J
Earth Ground
W
Important Information: refer to manual
X
Shock Hazard
~
Do not dispose of this product as unsorted
municipal waste. Go to Fluke’s website for
recycling information.
Electrostatic discharge Sensitive (ESDS)
P
This equipment meets the requirements of
all relevant European safety directives. The
equipment carries the CE mark.
Features
The following features are standard on all RUSKA 7615 Calibrators.
NIST Traceability
All Calibrator’s are calibrated using RUSKA deadweight gages, which are directly
traceable to the National Institute of Standards and Technology (NIST). All instruments
are provided with a NVLAP accredited calibration certificate.
Power Supply
The Calibrator’s universal power supply accepts AC voltages from 100 – 120 / 220 – 240
VAC. This outputs supply voltages of +5 VDC, +12 VDC, -12 Vdc, and 24 VDc which
are distributed to the Back Plane Board and Control Board.
Measurement While Control
The Calibrator simultaneously displays the commanded pressure, the actual pressure, and
the difference between the two. A bar graph shows the user how close the actual pressure
is to the commanded pressure, as well as how close the commanded pressure is to the
Calibrator’s full scale pressure.