Fluke Calibration 5522A, Getting Started

Page: 16 / 42

5522A
Getting Started
6
Unpack and Inspect
The calibrator is shipped in a container designed to prevent damage during shipping.
Inspect the calibrator carefully for damage and immediately report any damage to the
shipper. Instructions for inspection and claims are included in the shipping container.
When you unpack the calibrator, check for all the standard equipment listed in Table 2
and check the shipping order for any additional items ordered. Refer to Chapter 8 of the
5522A Operators Manual, “Accessories” for more information. Report any shortage to
the place of purchase or to the nearest Fluke Service Center (see “How to Contact Fluke”
in this manual). A performance test is provided in Chapter 7 of the 5522A Operators
manual, “Maintenance.”
If reshipping the calibrator, use the original container. If it is not available, you can order
a new container from Fluke by indicating the Calibrator's model and serial number.
Table 2. Standard Equipment
Item Model or Part Number
Calibrator 5522A
Line Power Cord See Table 3 and Figure 4
5522A Getting Started Manual 3795091
5522A Operators Manual on CD-ROM 3795084
How to Replace the Mains Power Fuse
W
Caution
To prevent possible damage to the product, verify the correct
fuse is installed for the selected line voltage setting. 100 V and
120 V, use 5.0 A/250 V time delay (slow blow); 200 V and 240 V,
use 2.5 A/250 V time delay (slow blow).
The line power fuse is accessible on the rear panel. The fuse rating is 5 A/250 V slow
blow fuse for the 100 V/120 V line voltage setting; 2.5 A/250 V slow blow fuse for the
220 V/240 V line voltage setting. Fuses that are not user replaceable are discussed in
Chapter 7, “Maintenance.”
To check or replace the fuse, refer to Figure 3 and proceed as follows:
1.
Disconnect line power .
2. Open the fuse compartment by inserting a screwdriver blade in the tab located at the
left side of the compartment and gently pry until it can be removed with the fingers.
3. Remove the fuse from the compartment for replacement or verification. Be sure the
correct fuse is installed.
4. Reinstall the fuse compartment by pushing it back into place until the tab locks.