Page 11
FW-F011-P-M_v0404_01_EN.docx
Step 2b: Changing the selected item in a list
SELECT
-key
This key is used to select the next item in the list (e.g. Disable
→
Enable).
At the end of the list, the selection will wrap around to the first selection.
CLEAR
-key
This key is used to select the previous item in the list (e.g. Enable
→
Disable ).
At the bottom of the list, the selection will wrap around to the last selection.
Step 3: Finishing the programming sequence
PROG
-key
During the programming sequence, this key is used to confirm the new value and
return to SETUP-level. To cancel the operation, either press the PROG-key for 3
seconds or wait for 20 seconds: the programming sequence is cancelled and the
former value is reinstated.
3.2.4
RETURNING TO OPERATOR-LEVEL
When all settings are configured correctly, the unit can be returned to OPERATE-level.
Please keep a record of all settings for later reference.
Use the control panel to return to OPERATE-level
PROG
-key
In order to return to the operator level, press the PROG-key for three seconds.
When no keys are pressed for 2 minutes, SETUP-level will be left automatically.
3.3
CONFIGURATION SETTINGS
All settings of the F011-P can be set via the control panel.
The following paragraphs give a detailed description of each setting.
3.3.1
OVERVIEW FUNCTIONS SETUP LEVEL
SETUP
FUNCTIONS
AND
VARIABLES
1
TOTAL
1.1
UNIT
L - m3 - kg - lb - GAL - USGAL - bbl - no unit
1.2
DECIMALS
0 - 1 - 2 - 3 (Ref: displayed value)
1.3
K-FACTOR
0.00001 - 199,999
1.4
DECIMALS K-FACTOR
0 - 6
2
DISPLAY
2.1
BACKLIGHT (optional)
off - on
2.2
BL. BRIGHTNESS
(optional)
1 - 5
3
POWER MANAGEMENT
3.1
LCD UPDATE
fast - 1 sec - 3 sec - 15 sec - 30 sec - off
3.2
BATTERY MODE
operational - shelf
4
FLOWMETER
4.1
SIGNAL
npn - npn_lp - reed - reed_lp - pnp - pnp_lp - namur -
coil_hi - coil_lo - active
5
OTHERS
5.1
TYPE / MODEL
F011-P
5.2
SOFTWARE VERSION
03.xx.xx
5.3
SERIAL NO.
xxxxxxx
5.4
PASS CODE
0000 - 9999
5.5
TAGNUMBER
0000000 - 9999999