E110-P
User Manual
FW_E110-P_M_v0301-01_EN
Page 15
4.5.2
INTERNAL ERROR
When an internal error occurs, the alarm flag starts flashing to indicate this.
If the alarm flag shows because of an internal error, the alarm code can be displayed by pushing the
SELECT-key repeatedly until the internal alarm screen is shown.
See
Section B: Troubleshooting [»60]
for a description of the codes.
RATE
L
TOTAL
ALARM
0
00
1
10
30
20
80
90
70
ALARM
0
00
1
10
30
20
80
90
70
Fig. 9:
Display with alarm flag and internal alarm screen
4.6
DATALOGGING (WITH TYPE ZL)
The data log function stores data records based on interval, daily contract hour and events in 3
separate logbooks. The logbooks and records can be reviewed in LOG-mode in the following way:
1. From OPERATOR-mode, press the CLEAR-key for 3 seconds.
2. Select the logbook by using the SELECT- and CLEAR-keys and open the logbook by pressing
the PROG-key.
LOG
0
00
1
10
30
20
80
90
70
ALARM
Fig. 10:
Logbook selection screen
3. After opening a logbook, the list with available records is shown with the newest (most recent)
record selected. Every record has a sequence number (record number), shown on the bottom
side, accompanied by the date and time the record was created. Use the SELECT- and CLEAR-
keys to scroll up and down through the list. When the down-arrow
is shown on the display,
the start of the list is reached (newest record), when the up-arrow
is shown, the end of the
list is reached (oldest record).
LOG
0
00
1
10
30
20
80
90
70
LOG
0
00
1
10
30
20
80
90
70
Fig. 11:
Example of record list with record 0003 selected (l) and empty record list (r)
