1. HAZARDOUS CONDITION WARNINGS
All Fluidmesh products are designed with safety in mind. However,
improper use of electronic and/or RF-emitting devices and/or their control
software has potential to cause serious injury and/or property damage. To
avoid such injury and damage, install, configure and operate Fluidmesh
products only if you are properly qualified to do so.
If any Fluidmesh hardware unit breaks down or malfunctions, emits smoke
or an unusual smell, if water or other foreign matter enters the unit
enclosure, or if the unit is dropped onto a hard surface or damaged in any
way, power off the unit immediately and contact an authorized Fluidmesh
Networks dealer for assistance.
If you are adjusting and/or controlling a Fluidmesh device using control
software such as the RACER™ interface or the device's local Configurator
interface, do not make configuration changes unless you know with
certainty that your changes will not negatively impact people or animals in
the vicinity of the device and its antennas.
1.1. Water ingress hazard
CAUTION
In all circumstances where the Fluidmesh 4200 FIBER will be
installed in an outdoor location, it is compulsory to mount the
Fluidmesh 4200 FIBER inside an FM-SHIELD auxiliary
mounting kit.
The FM-SHIELD auxiliary mounting kit is a proprietary
Fluidmesh solution, and is designed specifically to assure the
long-term durability and reliability of compatible radio
transceivers that have been installed in outdoor environments.
If you need further information regarding the recommended
usage of FM-SHIELD, contact your Fluidmesh Networks
representative.
Relevant technical specifications for FM-SHIELD can be found
in the
Fluidmesh FM-SHIELD installation manual.
Fluidmesh 4200 FIBER
© Fluidmesh Networks LLC
Page 6 of 180
