1
Flow Control Division
Kammer Control Valves
Valves for corrosive applications
Series 132000
Index
1
Using Flowserve valves and actuators correctly
2
Transport and storage
3
Installation
4
Intended use
5
Installation
6
Pressure test pipe section
7
Normal operation and maintenance
8
Trouble-shooting
9
Product description
10
Bonnet
11
Plug and seat
12
Bellows seal
13
Stem
14
Packing
15
Test connection
16
Quick check
17
Masintenance
18
Remove actuator from valve
19
Instal actuator on valve
20
Disassemble valve
21
Assemble valve
22
Trouble-shooting chart
KMEIM3202-01 -02.04
1
U S I N G K Ä M M E R V A L V E S A N D A C T U A T O R S
CORRECTLY
1.1
Use
FLOWSERVE control valves and actuators are intended
exclusively for control of mediums in an approved
pressure and temperature range after installation in a
piping system and connection of the actuator to the
control system.
The permissible pressure and temperature limits are
defined in the operating instructions for the individual
valve series.
1.2
Terms concerning safety
The safety terms
DANGER, WARNING, CAUTION
and
NOTE
are used in these instructions to highlight
particular dangers and/or to provide additional
information on aspects that may not be readily
apparent.
DANGER:
indicates that death, severe personal injury
and/or substantial property damage will occur if proper
precautions are not taken.
WARNING:
indicates that death, severe personal injury
and/or substantial property damage can occur if proper
precautions are not taken.
CAUTION:
indicates that minor personal injury and/or
property damage can occur if proper precautions are
not taken.
NOTE:
indicates and provides additional technical
information, which may not be very obvious even to
qualified personnel. Compliance with other, not
particularly emphasised notes, with regard to
transport, assembly, operation and maintenance and
with regard to technical documentation (e.g. in the
operating instruction, product documentation or on
the product itself) is essential, in order to avoid faults,
which in themselves might directly or indirectly cause
severe personal injury or property damage.
1.3
Safety Notes for Operator
The manufacturer is not responsible for the following
and it is therefore necessary to ensure the following
when using FLOWSERVE control valves:
1.3.1 Use valve as intended (Section 1)
DANGER:
Never operate a control valve whose
approved pressure/temperature range according to
the applicable documentation for the valve series is
not sufficient for the operating conditions. Moreover,
it must be ensured that the valve is approved for the
operating medium:
STOP!
