IPS SMART RTU ENGLISH 701-4101-01^ 6-14
Page
21
of
24
flowserve.com
10 DECLARATION OF CONFORMITY (TYPICAL)
We,
Flowserve Corporation
10920 West Sam Houston Parkway North
Suite 950
Houston, Texas 77064
USA
Declare in sole responsibility that the equipment:
ELD-102-X Single Point Transmitters
SELD-103-X Smart Point Transmitters
ELD-FA-403-Receiver, AO/DO and Serial Modbus
S-EGI-NB-4/20-AC/SP, Smart RTU
ELD-FA-525-AC/SP, Intelligent Repeater
Including all options and versions of the base model numbers to which this Declaration refers are in compliance
with the Directives and Norms specified herein.
1.1
EMC Directive 2004/108/EC
Basis for compliance:
The equipment has been assessed using the following standards and is supported by the following
technical documents:
EN 61326-1
2006
Electrical equipment for measurement, control and laboratory use -
EMC requirements - Part 1: General Requirements
EN 55011
2009
Industrial, scientific and medical equipment. Radio-frequency
disturbance characteristics. Limits and methods of measurement
Class A, Group 1
EN 61000-3-2,
EN 61000-3-3,
EN 61000-4-2,
EN 61000-4-3,
EN 61000-4-4,
EN 61000-4-5,
EN 61000-4-6,
EN 61000-4-8,
EN 61000-4-11
Series, Electromagnetic compatibility (EMC).
Under these environmental and use conditions:
Industrial Applications, Pollution Degree 2
Technical File Reference Number: 701-5000
Installation and use of this equipment shall comply with the relevant installation and use instructions.
1.2
Low Voltage Directive 2006/95/EC
Basis for compliance:
The Single point transmitters are fully-enclosed, intrinsically-safe apparatus and are considered to meet
the requirements as set forth in the standard below without further consideration:
EN 61010-1
2002
Safety requirements for electrical equipment for measurement, control
and laboratory use. Part 1 General requirements
Under these environmental and use conditions: Industrial Applications, Pollution Degree 2
