Removing the equipment
DANGER
Personnel working on pipes are exposed to
safety risks and may suffer severe injuries,
poisoning or even loss of life.
Make sure that no hot or hazardous
fluid is in the equipment or the pipes.
Make sure that the pipes upstream
and downstream of the equipment are
depressurised.
Make sure that the installation is
switched off and protected against
unauthorised or unintended activation.
Make sure that the equipment and the
pipes have cooled down to room
temperatures.
Wear protective clothing that is
suitable for the fluid and, if necessary,
wear protective gear.
19
For more information on suitable safety clothing and
safety gear refer to the safety data sheet of the fluid
in question.
CAUTION
Danger of bruising if the equipment falls
down.
When removing the equipment make
sure the it is safely held in place and
cannot fall down.
Suitable measures are for instance:
Equipment that is not too heavy may be
supported by a second person.
For heavy equipment use suitable lifting
equipment of sufficient strength.
Detach the end connections of the equipment
from the pipes.
Put the equipment onto a suitable base.
Store the equipment as described in section
on page 9.
Re-using equipment after storage
Observe the following instructions if you want to
remove the equipment and use it again somewhere
else:
Make sure that the equipment is free of any
fluid residues.
Make sure that all connections are in good
condition and leak-free.
If necessary re-work welded connections in
order to ensure that they are in good working
condition.
Use the equipment only for its intended purpose
and the service conditions for which it was
specified.
