8
GB
saw chain. In the event that it is dam-
aged or severed, immediately discon-
nect the plug from the socket.
Do not touch the cable before it has
been disconnected from the mains.
• Before use, carry out a visual in-
spection of the grinding disk. Do not
use grinding disks that are spalled,
cracked or otherwise damaged. Re-
place a worn grinding disk.
• Never operate the device without the
visual protection disk.
• Do not work with the device if you
are tired or after the consumption of
alcohol or tablets. Always take a break
from the work in good time.
• Do not use the device in an explosive
atmosphere or where sparks could
cause fire, explosion etc. Failure to
observe this will result in a risk of fire
or explosion.
• Keep your hands away from the
grinding disk and chain teeth when
the device is in use. Do not move the
chain by hand. This will cause a risk
of injury.
• Never place your fingers between the
grinding disk and rotary disk or be-
tween the grinding disk and protection
disk. This will cause a risk of crushing.
• The chain becomes hot during grind-
ing. Do not touch the machined loca-
tion, as there is a risk of being burnt.
• Use only grinding disks recommended
by the manufacturer. Do not use saw
blades.
• Switch off the device and disconnect
at the plug
- to release a jammed insertion tool,
- if the connecting cable is damaged
or tangled,
- in the case of unusual noises.
General description
The diagrams can be found on
the front flap.
Summary
1 On / off switch
2 Grinding head
3 Grinding disk cover
4 Handle
5 Fixing screws for grinding disk
cover
6 Adjusting screw and adjusting
nut for depth stopper
7 Guide rail
8 Grinding plinth
9 Stop notches
10 Locking screw for chain clamp-
ing unit
11 Scale for rake angle (+30° to -30°)
12 Chain clamping unit and rotary
disk
13 Chain tensioning and clamping
lever
14 Chain feed adjusting screw and
adjusting nut
15 Stopper
16 Cable hook (not shown)
17 Mains cable
18 Grinding disk and grinding disk
nut (not shown)
19 Fixing screws for the protective
screen
20 Protective screen
21 Ventilation openings (not shown)
22 Worktop
23 Screws (for mounting on the
worktop)
24 Nuts (for mounting on the worktop)
25 Mounting nut (for adjusting screw)
26 Recess (for adjusting screw)
27 Cutting tooth (saw chain)
28 Depth limiter lug (saw chain)
