Floorex Products Satellite 480 Generation3, Safety & Operator Manual

Page: 10 / 29

Page9 SATELLITE 480 Generation3
Floorex Products 1800 356 673
Magnetic plugs
67. Ensure the insert is not worn to less than 20mm diameter where the blade runs on the insert. This is
equivalent to the diameter of the section above it.
68.
69. Put the insert through the satellite disk and install the two parts onto the plug ensuring the insert goes
completely into the plug.
SP plugs
70. The SP versions of the Satellite machines don’t have magnetic plugs supplied. The SP versions have the SP
plug with a disc retaining rubber ring that retains the diamond tooling onto the machine.
71. Magnetic Plugs can be used but the SP plugs must be removed before to prevent damage to the unit.
72. The disc retaining rubber ring must be checked for wear or splitting before each operation to ensure the
safety of the machine is not compromised.
73. The SP Machines must be used with original manufacturer’s diamond tooling with the drive hole s to assure
safe operation. Using aftermarket tooling could void the warranty on the machine and could cause an unsafe
operation.
74. To remove the diamonds on the SP machines simply pull the tag on the disc retaining rubber ring. To reinstall
the tooling fit the disc and then work the ring over the face of the plug and into the grove making sure the
ring is bedded correctly in the grove.
Disc retaining
rubber ring