G4SZV-1/G4SZV-2 & G4SDZV-2 V1.10
Page 14
2.8.2
Menu Structure
The “normal” and default display is the Vc i.e. Total Volume in m3
The display can be switched between Vc (m
3
) & Meter balance £ using the left hand
button which is marked “A” shown on the display as “BAL” or “VOL”
While in the “normal” display the meter can be switched into the Menu structure below using the
Key
Note if no buttons are pressed for approx. 10 seconds, the meter will exit the menu and return to the Normal
display.
Level 1
Level 2
Level 3
Display read out
Comments
Use
Key to enter
Menu
structure
below
In the order
shown from
top to bottom
Typical display for
credit meter
METER
BALANCE
This returns the
display to the normal
volume display
INSTALL
SELECT this to start install process
See installation manual for screens and
process
NOTE This option is
ONLY shown if the
meter has not been
paired and is for the
use of installers only!
WAKE UP
This wakes up the meter and it will check
for any pending messages.
This allows the end
user or engineer to
force an extra wake up
(only once per 30
mins) This option will
disappear for 30 mins
once pressed.
METER BALANCE
INSTALL
WAKE UP
BLOCK USAGE or TIME OF USE
PREPAYMENT
(if prepayment is in use)
STATUS
ALERTS
MESSAGES
DEVICE INFO
USER SETTINGS
CONTACT
