1
) General
All Flomatic Electric Actuators are thoroughly tested and checked before shipment . If
installation will not occur immediately, actuator should be kept in a dry place. Please
DO NOT remove plugs from conduit entries until ready for wiring.
2) Operation
2.1) Auto/Manual Operation
Auto/ Manual Shift operation as follows:
1)
Manual Override:
Caution: Before engaging manual override power must be
off.
Push or Pull the hand/auto declutching lever to engage clutch. (Handwheel
may have to be “jockeyed” slightly.) After engaging clutch, turn handwheel
either to “Open” or “Closed”.
2)
Auto Operation by Motor: Once wiring is complete actuator is ready for
operation and will instantly operate once electric power is energized. If in
manual mode when electric power is re-energized, actuator will automatically
declutch and operate.
2.2) Valve Position Indication-
Actuator Top mounted Visual position indication shows “OPEN” and “CLOSED”
valve position.
3) Wiring Connections
3.1) Top Housing Cover Removal
Remove the 4 Socket head Housing Capscrews with a hex key wrench. Lift
housing cover from actuator base. Look for wiring diagram in plastic envelope.
Caution!! Read Before Operation!!
When the actuator is operated for the 1
st
time it is important to check the
correct rotation of the motor. Otherwise serious damage may occur.
1) Place Valve position at 45 degrees by turning the handwheel , energize
the actuator to open or close and check proper valve rotation direction.
2) If Rotation direction is reverse, stop immediately and recheck wiring.
FCEL Electric Actuator Operating Manual
