4.75
(120)
3.5
(90)
3.44
(87)
“Quad II Diaphragm”
Models
4125 Series
Bilge Pump
FEATURES
• Self-Priming
• Dry Running
• Soft, Noise Absorbing Mounts
• 300 Gallons Per Hour
• Corrosion Resistant Materials
• Models Meet U.S.C.G. Electric Standards
SPECIFICATIONS
Motor
: Permanent Magnet, Ball Bearings on both
Front and Rear Endbells. CE Models are fully
suppressed.
Pump
:
Four chamber diaphragm positive displace-
ment design; Self-priming up to 6 ft. suction
lift; Pump able to run dry without damage;
Removable port to hose connectors.
(Available on 12 & 24V d.c. Models)
Your “Quad II” pump is designed to self-prime up to 6
feet suction lift (vertical distance from bilge pick-up to
pump inlet). The maximum recommended discharge
head (distance outlet is above pump) is 15 feet. It is
recommended you utilize an automatic on-off switch so
that the pump is turned off when not in use. The “Quad
II” is able to run dry (no liquid) for extended periods,
however, this could cause needless battery drain.
OPERATION
Pump Series
Dimensions - Inches (mm)
Weight
Height
Width
Length
lb. (kg)
4125-XXX
3.75 (95)
6.3 (160)
9.2 (234)
6.0 (2.8)
AMP DRAW
FLOW
MODEL*
VOLTS
@ 10 psi (0.7 bar)
GPM (l/min)
4125-114
12V dc
8.5
5.0 (18.9)
4125-314
24V dc
3.6
5.0 (18.9)
4125-343
32V dc
2.8
5.0 (18.9)
* CE fully suppressed models are identified by a prefix “R” and a CE mark on the label. (i.e. R4125-314).
Self Declaration Of Conformance (SDOC) is available upon request.
Model 4125 Series
