Action
Step
Open the lid of the battery compartment by pressing its locking mechanism.
1
The battery release spring will push out the battery from the battery compartment.
2
Close the lid of the battery compartment.
3
For more information about the battery system, see section 12 – Electrical power
system on page 129.
8.8.7
Removing & attaching the remote control from the camera handle
➲
The remote control is mounted on the camera handle by means of a fixed front
latch and a rear spring-loaded latch. See the figure on page 72.
8.8.7.1
Removing the remote control
10397203;a3
Figure 8.6 Removing the remote control
Action
Step
Firmly hold the camera in your left hand and grab the handle of the remote control
in your right hand.
1
Pull the handle backwards until the front of the handle is released from its latch.
2
You can now remove the remote control from the camera handle.
3
8.8.7.2
Attaching the remote control
➲
The remote control should not be attached to the camera handle when you use
the heat shield. The heat shield does not protect the remote control from heat.
8
62
Publ. No. 1557954 Rev. a155 – ENGLISH (EN) – February 7, 2006
8 – Tutorials
Summary of Contents for ThermaCAM P65
