427-0100-00-12 Version 100
December 2018
32
The information contained herein does not contain technology as defined by EAR,15 CFR772, is publicly available, and therefore not subject to EAR.
Configuration
3.1.5
Alarm Page
Two default alarms have been provided to react to motion detected in a video analytics region.
•
Visible LED on Motion
—When a alarm is triggered by the video analytics, the visible LEDs are
turned on. Enabled by default.
•
Output on Motion
—When a alarm is triggered by the video analytics, the system generates an
output signal at the I/O connector as well as a virtual output for connected VMS systems.
Enabled by default.
By default, the Alarm logic can also process an input signal to Arm/Disarm the video analytics
detection.
•
Arm/Disarm Analytics with Input
—An input signal on the I/O connector as well as a virtual
input from a connected VMS systems can arm or disarm the video analytics. Disabled by default.
Click to toggle
3.1.6
Audio
The Audio page provides configuration settings for the audio line out via the I/O connector. When
audio is On, you can adjust the gain from 0-100 percent. The default gain is 50 percent.
