Configuration
44
427-0200-00-12 Revision 100
November 2019
This document does not contain any export-controlled information.
Enable or disable digest authentication for the FLIR CGI control interface. The default setting is
On
(enabled).
Firewall Settings
For enhanced security, the camera has a firewall that you can enable by clicking
On
. By default, when
you enable the firewall, the following services are set to
Allow
, which means they remain enabled and their
default ports remain open:
·
SSH
·
FTP
·
RTSP
·
UPNP
·
Nexus Discovery
·
Nexus SDK
·
TRK
·
ICMP
To disable a service and its default port, click
Block
.
Caution
Disabling services and ports can affect product functionality.
Changes to Services settings do not immediately take effect. To apply changes to these settings, click
Save
and then reboot the camera.
4.8
ONVIF Page
The ONVIF page provides settings for auxiliary commands and for output actions.
To configure the ONVIF interface:
1. Select the number of auxiliary commands (up to seven) and the number of output actions (also up to
seven).
2. For each auxiliary command action, specify the ONVIF command name.
3. For each auxiliary command action, and separately for each ON and OFF output action, select one of
the following:
o
None
o
Thermal Polarity Toggle
—Toggles the thermal video polarity (see
). For example, toggles the colorization from WhiteHot to BlackHot or vice versa; RedHot to
RedHotInverse or vice versa; and so on.