FLIR Raymarine CAM220IP, Installation Instructions Manual

Page: 16 / 54

3.5 Typical systems
Note: For information on how to connect the
product, refer to the Chapter 4 Cables and
connections section. For information on available
cables and accessories, refer to the Chapter 11
Spares and accessories section.
• Basic multifunction display (MFD) system:
You can connect the product directly to a
multifunction display using the supplied RJ45
coupler, and an additional adaptor cable (refer to
the
4.5 Network connection section for details). If
you are connecting the product to an a, c, e, or
eS Series MFD, the camera requires a separate
power source, either connecting directly to your
vessel’s 12 V dc power supply, or using a Power
over Ethernet (PoE) injector (refer to the
4.4
Power connection section for details). If you are
connecting the product to a gS Series MFD,
the camera can be supplied PoE by the display,
provided the display has the necessary remaining
PoE allocation. Refer to the gS Series installation
and operation instructions for details on PoE
allocation, and also to the
4.4 Power connection
section.
• Multiple camera system:
You can use a Raymarine network switch to
connect multiple cameras to a single MFD. Each
camera requires a separate power supply, unless
the switch is capable of providing PoE, or if the
camera is connected directly to a gS Series
MFD supplying PoE. Refer to the
4.5 Network
connection and 4.4 Power connection sections
for details.
• PC / laptop system:
You can connect the product to a PC or laptop
computer, directly via the computer’s Ethernet
connector, or indirectly via a Raymarine network
switch. Refer to the
4.5 Network connection
section for details. When connected to a PC or
laptop computer, you can access the product’s
built-in web interface.
3.6 Warnings and cautions
Important: Before proceeding, ensure that you
have read and understood the warnings and
cautions provided in the
Chapter 1 Important
information section of this document.
16 CAM220IP