Disclaimer
Raymarine does not warrant that this product is
error-free or that it is compatible with products
manufactured by any person or entity other than
Raymarine.
Raymarine is not responsible for damages or injuries
caused by your use or inability to use the product,
by the interaction of the product with products
manufactured by others, or by errors in information
utilized by the product supplied by third parties.
EMC installation guidelines
Raymarine equipment and accessories conform to
the appropriate Electromagnetic Compatibility (EMC)
regulations, to minimize electromagnetic interference
between equipment and minimize the effect such
interference could have on the performance of your
system
Correct installation is required to ensure that EMC
performance is not compromised.
Note:
In areas of extreme EMC interference,
some slight interference may be noticed on the
product. Where this occurs the product and the
source of the interference should be separated by
a greater distance.
For
optimum
EMC performance we recommend
that wherever possible:
• Raymarine equipment and cables connected to
it are:
– At least 1 m (3 ft) from any equipment
transmitting or cables carrying radio signals e.g.
VHF radios, cables and antennas. In the case
of SSB radios, the distance should be increased
to 7 ft (2 m).
– More than 2 m (7 ft) from the path of a radar
beam. A radar beam can normally be assumed
to spread 20 degrees above and below the
radiating element.
• The product is supplied from a separate battery
from that used for engine start. This is important to
prevent erratic behavior and data loss which can
occur if the engine start does not have a separate
battery.
• Raymarine specified cables are used.
• Cables are not cut or extended, unless doing so is
detailed in the installation manual.
Note: Where constraints on the installation
prevent any of the above recommendations
,
always ensure the maximum possible separation
between different items of electrical equipment, to
provide the best conditions for EMC performance
throughout the installation
Suppression ferrites
• Raymarine cables may be pre-fitted or supplied
with suppression ferrites. These are important for
correct EMC performance. If ferrites are supplied
separately to the cables (i.e. not pre-fitted), you
must fit the supplied ferrites, using the supplied
instructions.
• If a ferrite has to be removed for any purpose (e.g.
installation or maintenance), it must be replaced in
the original position before the product is used.
• Use only ferrites of the correct type, supplied by
Raymarine or its authorized dealers.
• Where an installation requires multiple ferrites to
be added to a cable, additional cable clips should
be used to prevent stress on the connectors due
to the extra weight of the cable.
• If your camera installation requires long cable
runs, you may need to fit additional ferrites to
maintain acceptable EMC performance.
Connections
to
other
equipment
Requirement
for
ferrites
on
non-Raymarine
cables
If
your
Raymarine
equipment
is
to
be
connected
to
other
equipment
using
a
cable
not
supplied
by
Raymarine,
a
suppression
ferrite
MUST
always
be
attached
to
the
cable
near
the
Raymarine
unit.
Declaration
of
conformity
Raymarine
UK
Ltd.
declares
that
this
product
is
compliant
with
the
essential
requirements
of
EMC
directive
2004/108/EC.
The
original
Declaration
of
Conformity
certificate
may
be
viewed
on
the
relevant
product
page
at
Product
disposal
Dispose
of
this
product
in
accordance
with
the
WEEE
Directive.
The
Waste
Electrical
and
Electronic
Equipment
(WEEE)
Directive
requires
the
recycling
of
waste
electrical
and
electronic
equipment.
CAM200IP / CAM210IP
