FLIR Quasar Gen II Series CM-6212 H1-I, User And Installation Manual, Page: 76 / 146

September 6, 2017 70
Configuration and Operation
CM-6212 H1-I User and Installation Guide
Triggered Action
The Administrator can specify various alarm actions to be taken when an alarm is triggered. See the IO
screen for details. The options are listed below.
·
Enable alarm output – Check this box and select the predefined type of alarm output (low or high )
to enable alarm relay when a network failure is detected.
·
Send message by FTP – Select whether to send an alarm message by FTP when a network
failure is detected.
·
Record video clip – Select this box in order to save the alarm-triggered recording into a microSDXC
card or the NAS.
·
Send message by E-Mail – Select whether to send an alarm message by e-mail when a network
failure is detected.
Click SAVE to save the network failure detection settings.
9.3.4.3 Tampering
The Tampering screen enables the camera to deal with tampering (such as blocking, paint-spraying, and
obscuring the lens, etc.). Using video analysis, the camera can react to such events by sending
notifications or uploading snapshots to the specified destination(s). Detection of camera tampering is
achieved by measuring the differences between the older frames of video (which are stored in buffers) and
more recent frames.
Tampering Screen
Tampering Alarm
The Administrator can select from the following options:
·
Select Off to disable the tampering alarm (default setting).
·
Select On to enable the tampering alarm.
·
Select By Schedule to set a schedule. Then click Please Select to select up to 10 schedules from
the drop-down list that opens. The selected schedules are displayed in the Please Select text box.
To set a schedule, open the Schedule tab.
Click SAVE after configuring the settings.