FLIR Quasar Gen II Series CM-6212 H1-I, User And Installation Manual, Page: 18 / 146

September 6, 2017 12
Hardware Description
CM-6212 H1-I User and Installation Guide
3.2 Internal Connectors
The camera housing includes includes a microSD card drive, which supports a 128GB microSDXC card
(Class 10). It also includes a Reset button for easily resetting the camera. The button enables you to save
configured settings and to restore factory defaults, including network settings.
Note:
It is not recommended to record with the microSD card for 24/7 continuously.
Internal Camera Housing
To perform a hard reset to full factory defaults using the Reset button
1. Insert a pointed object into the Reset button.
2. Press the button for 30 seconds. Both LEDs on the RJ45 connector are extinguished. After one
second, the green network LED flashes once and then remains lighted. The yellow activity LED
flashes as soon as it detects network activity. The unit returns to full factory defaults.
Note:
Desiccants are included inside the camera housing and must be replaced every time the housing is
opened. After desiccants are replaced, reconnect the front housing to the camera as soon as possible.
Otherwise, the desiccant will become damp and cannot be used. For instructions on removing the
desiccant, refer to the
Desiccant User Guide .