FLIR Quasar Gen II Series CM-6212 H1-I, User And Installation Manual, Page: 118 / 146

September 6, 2017 112
Configuration and Operation
CM-6212 H1-I User and Installation Guide
Manual Mode
Fixed Shutter Speeds
1/300 1/350 1/6 1/8
1/215 1/250 1/3 1/4
1/150 1/180 1/1.5 1/2
·
Gain – A nominal video signal level is usually 1-volt peak-to-peak for composite video, 0.7 volts for
component or RGB video, or 0.3 volts for the chrominance subsection, at which level a fully
saturated picture is transmitted to the acceptor. However, for cases where the video signal is
attenuated, a low-noise, high-gain analog amplifier is built into quality video processing equipment.
This amplifier provides video gain control whereby the video signal can be boosted or reduced. Dark
pictures caused by low level lighting are easily adjusted. The
Gain drop-down menu turns the video
gain Off or moves it in steps from 1 to 9.
Click
SET
when you finish setting the gain.
9.5.2 Picture Adjustment
Adjustment of some qualities of the video is made possible by selecting Picture Adjustment in the Camera
tab. Brightness, Sharpness, Contrast, Saturation and Hue may all be adjusted via drop-down menus from
this window, as shown below.
Camera Settings Screen – Picture Adjustment
Brightness
You can adjust the image’s brightness by adjusting this parameter. Select from the range between -12 to
+13. To increase video brightness, select a larger number. The default setting is
DEFAULT. Click SET to
confirm the new setting.
Sharpness
Increasing the sharpness level can make the image look sharper, especially enhancing the object’s edge.
Select from the range between 0 to +15. The default setting is
DEFAULT. Click SET to confirm the new
setting.