FLIR Quasar Gen II Series CM-6212 H1-I, User And Installation Manual, Page: 111 / 146

105 September 6, 2017
Configuration and Operation
CM-6212 H1-I User and Installation Guide
Quality
The Encoding Priority function enables the user to adjust the quality of the picture along a single axis The
slider is configured according to Quantization Parameter (QP) values. Setting QP to a high value increases
the bit rate and results in high compression, but this is at the expense of poor decoded image quality.
Setting QP to a low value results in better decoded image quality, but with lower compression.
Encoding Priority should be set for each H.264 stream. The slider ranges from 1 (low bit rate) to 10 (high
picture quality). The default setting is 7 . Click SAVE to confirm the setting.
Note:
The Encoding Priority setting is displayed only when H.264 is selected.
Compression Information Setting
Select the checkbox to display compression information on the Home page. The default setting is Display
compression information in the home page . Click SAVE to confirm the setting.
CBR Mode Setting
To enable CBR mode on a stream, select the checkbox for that stream. Click SAVE to confirm the setting.
9.4.3 Video OCX Protocol
From the Video OCX Protocol page, you can select various protocols for streaming media over the
network. In the case of multicast networking, select Multicast mode .
Video OCX Protocol Screen