FLIR QUASAR CP-3211, User And Installation Manual, Page: 28 / 164

September 12, 2016
20
Installation
CP-3211/CP-4221 User and Installation Guide
5.3
Mounting Instructions
The following are four general methods of mounting the Quasar HD PTZ series cameras.
§ Ceiling Mount
§ Wall Mount
§ Corner Mount
§
Pole Mount
Note:
Within each general method, there may be several mounting types available as optional packages.
See
Camera and Mounting Accessories .
5.3.1 Initial Camera Configuration
To perform the initial camera configuration
1.
Unpack the camera.
Rotate and remove the protective cover.
2. Remove the PE cloth sheet and lens cap. Attach the dome cover to the body.
3. On the camera back plate, plug the Cat 5 cable into the camera’s Ethernet port. If the
network does not use IEEE 802.3at PoE Plus, plug a properly rated 24VAC power supply into
the cameras’ power connector terminal block
.
Caution:
Make sure that the power supply connection matches the positive and negative polarity
on the unit.
Attention:
Assurez-vous que le branchement à l'alimentation corresponde aux polarités positive et
négative sur l'unité.
4.
Verify that the LEDs on the RJ45 connector illuminate green (indicating a stable network
connection) and flashing yellow (to indicate network activity).
5.
Do the following:
a. Copy and run
dna.exe
(see note below) from the included CD.
b. Click the icon.