FLIR QUASAR CP-3211, User And Installation Manual, Page: 121 / 164

113
September 12, 2016
Configuration and Operation
CP-3211/CP-4221 User and Installation Guide
9.5.3 Auto Pan
From the Auto Pan page, up to four Auto pan paths may be defined. An Auto pan path scans an area
horizontally from left to right or right to left at a user-defined speed.
Auto Pan Screen
To set up an Auto pan path
1. From the Auto pan setting section, select a path number from the Auto pan path drop-down list.
2. In the Live View pane, move the camera view to the desired start point and click Start Point: Set .
Note:
The zoom ratio at the start point is maintained for the entire Auto pan path.
3. Select a speed setting from the Speed drop-down menu, from 0 (low) to 3 (fast).
4. Select a direction for the path from the Direction drop-down menu.
5. In the Live View pane, move the camera view to the desired end point. Click End Point: Set .
To run an Auto pan path
1. Under Auto pan run , select the desired Auto pan path from the drop-down list.
2. Click Run . The camera will move along the defined Auto pan path.
To view the camera in full screen mode as it follows the Pattern Line
1. Move the cursor onto the Live View pane.
2. Right-click and select
Full screen .
3. Double-click to exit full screen mode.
To stop running an Auto pan path
1. Move the cursor to the Live View pane and move the camera in any direction.