FLIR E70353, Nstallation & Operation Instructions

Page: 59 / 104

5.2 JCU–3 Mounting
Note: The JCU-3 joystick control unit is supplied with M100/M200 Series camera
system kits, and separately as an optional accessory. JCU-3 units are not supplied
with cameras purchased individually. See System kits for more information about
system kits and parts supplied.
Location requirements
When planning the installation location, consider the following points:
• Select a position on your vessel that is close to a display showing the camera
video output.
• Ensure the JCU-3 is mounted at least 1 m (39.4") away from any equipment fitted
with a magnetic compass.
• The JCU-3 can be mounted to a dash or other surface in any orientation.
• Consider cable lengths and cable routing.
Removing the keypad mat
To gain access to the mounting hole locations, the keypad mat must be removed.
Tip To help prevent scratching the product, cover the tip of your screwdriver blade with
a small piece of insulation tape.
1. Using a thin, flat bladed screwdriver insert the tip of the screwdriver into the gap
between the edge of the keypad mat and the keypad housing, at a location between
locking tabs.
2. Gently lever the keypad mat away from the keypad to release the keypad mat.
Take care not to bend the keypad mat during removal.
Mounting
59