![Fliegl ASW 110 Operating Instructions Manual Download Page 64](http://html1.mh-extra.com/html/fliegl/asw-110/asw-110_operating-instructions-manual_2305243064.webp)
Use and operation
62
7.1.3
Coupling the trailer
Always follow the instructions in section 4.2 for the coupling and uncoupling process
and read through this section carefully before first-time start-up.
-
Move the towing device of the towing vehicle or the drawbar eye of the trailer to the correct
height. See section 7.1.2.
-
Open the towing device on the towing vehicle.
-
Move the towing vehicle backwards until the drawbar eye engages in the towing device.
-
Secure the towing vehicle against rolling away (parking brake) and turn off the engine.
-
Check whether the towing device is engaged.
-
If the trailer is equipped with forced steering, the control cylinder of the forced steering must be
attached to the mounting point on the towing vehicle.
-
Establish the electrical connections and connect the service brake.
-
Establish the compressed air supply between the towing vehicle and trailer, if applicable.
(See section 4.2.3)
-
Establish the hydraulic connections between the towing vehicle and trailer.
Connect all hydraulic lines to the towing vehicle in pairs (double-action).
For labelling to identify connection points, see the stickers on the vehicle and on the couplings.
(See section 16.1)
Hydraulic connections
Connect all hydraulic lines to the towing vehicle in pairs (double-action).
For labelling to identify connection points, see the stickers on the vehicle and on the couplings.
Check all hydraulic lines for damage and leaks on a daily basis. Replace all
hydraulic hoses completely every 6 years.
Releasing the parking brake
The hand brake lever is located on the right of the traction bar.
Parking brake version:
To release the parking brake on the trailer, apply the handbrake lever a little (drawbar eye
direction). It will trigger itself. Then reset the lever arm.
Spindle brake version:
To release the parking brake on the trailer, turn the crank anti-clockwise.
Tristop version:
To release the parking brake on the trailer, operate the relevant release button.
-
Remove the wheel chocks and stow them.
-
Start the towing vehicle engine.
-
Retract the supporting mechanism and, if possible, secure it in place.
-
Check the service brake and parking brake before starting work.
The parking brake is applied by pulling in the direction of the drawbar eye.
The PB is released by letting down the handbrake lever.
Road traffic regulations must also be observed when using the brakes (including the
parking brake).