Page 9
© 2015 FlexRadio Systems, v1.0.2
Installing the FLEX-6300 ATU Assembly
Once the top cover has been removed, the ATU assembly can be installed.
Preparing the ATU Assembly
Locate the short (2.7” / 6.86 cm) RG-316 MCX cable assembly. Carefully insert one end of the mini RG-
316 Coax cable assembly into the gold MCX “snap on” connector labeled
X2
on the ATU board by pressing
down gently until it is completely seated. The X2 connector is located on the edge of the ATU board,
opposite of the notched end as shown below.
