S E T U P F O R M
C H A P T E R 4
Hint:
Check the Expert box to reveal many more standard TX Profiles. See
below.
Transmit Filter
Figure 106: Transmit Filter Controls
High
: Controls the high cut of the Transmit Filter.
Low
: Controls the low cut of the Transmit Filter.
Note 1:
You will receive a “good practice” warning if the transmit filter
bandwidth exceeds 3kHz.
Note 2:
You can view the transmit filter on the Panadapter or Waterfall
displays when you enable
Show TX Filter on Display
on the Front
Console.
DC Block
Attempts to block any DC noise from entering the filter.
Tune
Power:
Sets the power in Watts to be used whenever the
TUN
(Tune) function is used on the
Front Console (sets the
Drive
control). Changes made to the
Drive
level while
TUN
is active
will be reflected in this control.
TX Meter:
Selects which TX Meter to use when
TUN
on the Front Console is clicked.
[The rest of this page has been left blank intentionally]
112
2003-2008 FlexRadio Systems
Figure 107: Tune Settings
