2
GENERAL SAFETY RULES
WARNING!
READ AND UNDERSTAND ALL INSTRUCTIONS.
Failure to follow all instructions listed below may result in electric shock, fire and/or serious
personal injury.
SAVE THESE INSTRUCTIONS
WORK AREA
Keep your work area clean and well lit.
Cluttered benches
and dark areas invite accidents.
Working temperature.
This worklight is design to be use at
normal room temperature. If use under 0°C (32°F) the battery
will discharge more fast.
FLEXLITE is design to be used in industrial environment
under rain, snow and dust. But FLEXLITE product can not
be immerse in water. If the working area is moist and dusty,
some particles will stick on the fan or heatsink and reduce the
performance. See maintenance section to remove any dirt.
DANGER!
Never connect / disconnect or use an external
power supply or charger in hazardous area.
DANGER!
Never connect or disconnect the connector on
the lighthead or any extension cord when the
power is on or in hazardous area.
ELECTRICAL SAFETY
A battery operated worklight FLXFLOOD7.5K must be
connect properly to Flexlite charger to be recharged.
Using another charger may create a risk of fire.
Use only FLEXLITE adaptor.
SERVICE
Worklight service must be performed only by qualified
repair personnel.
Service or maintenance performed by
unqualified personnel may result in a risk of injury.
When servicing a worklight, use only identical
replacement
parts.
Follow
instructions
in
the
Maintenance section of this manual.
Use of unauthorized
parts or failure to follow Maintenance Instructions may
create a risk of shock or injury
.
STORAGE TEMPERATURE
Store worklight at room temperature between 4 and 27°C (40
and 80°F) for best results.
When transporting or temporarily storing in a vehicle,
temperature range should be greater than -30°C (-22°F) but
no more than 66°C (151°F).
Storing worklight at temperatures greater than 76°C
(169°F) for extended periods of time (more than 2 hours)
may cause damage to worklight and possible fire or
explosion.
SPECIFIC SAFETY RULES
Know your worklight. Read operator’s manual carefully.
Learn its applications and limitations, as well as the
specific potential hazards related to this worklight.
Following this rule will reduce the risk of electric shock, fire,
or serious injury.
Lens and housing become hot during use:
During or immediately after use, don’t lay worklight flat
on lens surface or place lens area in contact with a plastic
or fabric covered surface.
Handle worklight with care around any flammable surface.
Do not use or permit use of worklight in bed or sleeping
bags. This worklight lens can melt fabric and a burn injury
could result.
Use only the adaptor recommended for use with your
worklight.
Do not substitute any other adaptor. Use of
another adaptor could cause batteries to explode causing
possible serious injury.
See FEATURES for details.
Do not charge battery pack in a damp or wet location.
Following this rule will reduce the risk of electrical shock.
Your battery worklight should be charged in a location
where the temperature is more than 10°C (50°F) but less
than 37°C (99°F).
Do not disassemble your worklight.
Do not permit children to use worklight unsupervised.
It
is not a toy. The temperature of the light head will become
hot after being on for only a short period of time. This hot
temperature can cause burn injury if touched and can create
sufficient heat to melt some fabrics.
Stay alert.
Watch what you are doing and use common
sense. Do not rush.
If wrapped or in contact with fabrics, the worklight lens
can produce sufficient heat to melt some fabrics.
To avoid
serious personal injury, never allow the worklight lens to
come in contact with anything.
DANGER!
Never store FLEXLITE (battery models)
under sunshine.
