webdyn.com
V2.0 subject to changes | Webdyn © by Flexitron Group
20
2. Installation
2.1 Prerequisite
Since the role of the hub is to send the data it collects to an IS, the installation requires sufficient
knowledge of the hub, but also of the information system to which it sends its data.
The following is required to ensure proper installation:
• To have this user manual to hand.
• To have a screwdriver suitable for the types of connectors and screws available on the
WebdynEasy W M-Bus hub.
• To have knowledge of the parameters to connect to the IS information system.
• To have a SIM card with an activated data subscription and knowledge of the provider’s APN.
• To have a magnet.
It is also strongly recommended to have the elements described below for any intervention on site and
to install the product.
• Use a remote antenna if radio or cellular modem reception is deteriorated.
• Have an Android smartphone with the WebdynEasy W M-Bus app installed to facilitate product
configuration.
•
Have a PC for product configuration or update via USB.
2.2 Unpacking
2.2.1 Contents
The WebdynEasy W M-Bus hub comes standard with:
• A curved SMA antenna for the modem (internal).
• A curved SMA antenna for the radio (internal).
• A battery pack.
2.2.2
Identification
The commercial reference differs depending on whether or not the hub includes a customer configuration.
The commercial reference is composed as follows:
•
Without configuration: the commercial reference is WG0612-A12.
•
With configuration: the commercial reference is WG0612-A12 to which the customer identifier
is added. For example, the following reference can be obtained: WG0612-A12-WG.
A unique identifier called UID is assigned to each WebdynEasy W M-Bus. It is used to configure the
product and recognise it when you have several WebdynEasy W M-Bus products.
