8 Start-up
FLUXUS G831ST-HT
8.2 Switching on
71
UMFLUXUS_G831ST-HTV1-0EN, 2021-06-01
8.2
Switching on
As soon as the transmitter is connected to the power supply, the menu is displayed in the adjusted language. The
language can be changed.
If the transmitter was switched off during the measurement, the message
Measurement started
will be displayed after
connecting the transmitter to the power supply. The measurement continues with the parameters set last.
By pressing BRK in the program branch
Measurement
it is possible either to stop the measurement or to display the
current parameter settings.
Operation state indication
The operation state is indicated by LEDs above the display.
8.3
Program branches
The following schema shows the program branches. For a detailed overview of the menu structure see annex A.
Notice!
The parameters cannot be changed during the measurement. The measurement has to be stopped in order to
change the parameters.
Tab. 8.1:
Operation state of the transmitter
LED off
transmitter in idle state
LED lights green
signal quality of the measuring channel sufficient for a measurement
LED lights red
signal quality of the measuring channel not sufficient for a measurement
Parameters
Measurement
Options
Special functions
Transducer parameters
Measuring point number
Physical quantity
System settings
Pipe parameters
Transducer distance
Units of measurement
Inputs
Fluid parameters
Transducer positioning
Outputs
Current output
Length of extension cable
Transducer pair distance
Input assignment
Measurement
Measurement
Remote functions
Data logger
Event triggers
Snaps
Special settings
Communication
Units of measurement
Totalizers
Dialogs/Menus
Parameter record
Libraries
Minimum pipe diameter
