Flexim FLUXUS F502BT, Operating Instruction

Page: 69 / 162

8 Start-up
FLUXUS F502TE 8.5 Language
69
UMFLUXUS_F502TEV1-5EN, 2020-05-29
8.5 Language
The language can be selected with the following HotCodes:
When the last digit has been entered, the main menu is displayed in the selected language.
The selected language remains activated when the transmitter is switched off and on again. After an initialization of the
transmitter, the language is reset to the default language.
8.6 Initialization
During an initialization (INIT) of the transmitter, the settings in the program branches Parameter and Output Options
and some of the settings in the program branch Special Funct. are reset to the default settings of the manufacturer.
Proceed as follows to execute an initialization:
• When switching on the transmitter: keep BRK and C pressed.
• During the operation of the transmitter: press BRK, C and ENTER at the same time. A reset is executed. Release only
ENTER. Keep BRK and C pressed.
After the initialization has been executed, the message INITIALISATION DONE is displayed.
After the initialization, the remaining settings of the transmitter can be reset to the default settings and/or the stored measured
values can be deleted.
• Select yes to reset the remaining settings of the transmitter to factory default or no to keep them unchanged.
• Press ENTER.
If
yes is selected, the message FACTORY DEFAULT DONE will be displayed.
• Select yes to delete the stored measured values or no to keep them.
• Press ENTER.
This display will only be indicated if measured values are stored in the transmitter.
function HotCode
reset of the display to medium contrast 555000
language 9090xx
manual input of the lower limit for the inner pipe diameter 071001
activation/deactivation of the SuperUser mode 071049
change of the transmission parameters for service interface RS232 232-0-
language HotCode
Dutch 909031
French 909033
Spanish 909034
Czech 909042
English 909044
Polish 909048
German 909049
FACTORY DEFAULT
Delete Meas.Val.