Flexim FLUXUS F401, Operating Instruction

Page: 39 / 160

7 Connection
FLUXUS F401 7.1 Transducers
39
UMFLUXUS_F401V2-1EN, 2020-06-12
7 Connection
The connections of the outputs, transducers and the power supply unit are located on the
rear side of the transmitter, see Fig. 7.1.
7.1 Transducers
It is recommended to run the cables from the measuring point to the transmitter before
connecting the transducers to avoid load on the connectors.
Connection
• Remove the protective cap from the transmitter.
• Remove the protective cap from the transducer. Pull the knurled ring slightly back.
• Insert the connector into the transmitter socket. The red point on the connector has to
be aligned with the red marking on the socket.
Fig. 7.1: Connections on the transmitter
1 – outputs
2 – transducers
3 – power supply unit/battery charging unit
1 2 3