3
Marquage CE
This equipment complies with the essential requirements of Regulation (UE) 2016/426 « Gas devices ». It is
registered under the No.1312DL6489 on the 19th of February 2021, standards EN17082:2019.
The devices in this manual comply also with following directives:
-
Low voltage 2014/35/UE,
-
Electromagnetic compatibility 2014/30/UE,
-
Ecodesign 2009/125/CE, according the requirements of regulation (UE) 2016/2281-2282-2283 of the 30th
of November 2016.
Liability
The devices must be installed by qualified professional workers, respecting the regulations and decrees in
force, and in accordance with the instructions shown in this instruction manual. The installer is required to
establish installation conformity certificates produced by the ministries responsible for the construction and
safety of gas. References to standards, rules and directives mentioned in this manual are given for
information purposes and are only valid at the date of printing this manual.
Receipt and storage
The appliance is delivered on a wooden pallet protected by a cardboard packing and a plastic film. It is
essential to check the condition of the delivered equipment (even if the packaging is intact) and its
conformity with the order.
In case of damage or missing parts, you must report the observations on the transport company’s receipt
form in the most precise way possible, “subject to unpacking” has no legal value, and then you must
confirm those reservations by registered letter within 48h to the transport company. We remind you that it is
the responsibility of the buyer to check the delivered merchandise, no recourse will be possible if this
procedure is not respected.
Store the equipment in a clean and dry room, away from shocks, vibration, divergences in temperature and
in an ambient environment with a rate of hygrometry lower than 90%.
Recycling and end of product service life
This device is mainly built using materials that can be recycled, at the end of its service life, it is
important to pay particular attention to its destruction. Some components, such as electric
equipment, are subject to special legislation, applicable national regulations must be respected
when disposing of them.
1- For the disposal of the product and parts, use public or private waste disposal contractors.
2- For further information on the proper disposal of the product, contact the local authorities, the refuse
collection and processing department or the point of sale where the product was purchased.
Appliances or equipment bearing this symbol must not be disposed of with household waste, but must be
collected separately.
Proper recycling helps to prevent environmental damage and health risks.
This equipment must be used expressly for the purpose for which it has been designed and
manufactured for. Any contractual liability of Flexiheat
is therefore excluded in case of damage undergone
by persons, animals or goods, following errors in installation, settings, maintenance and inappropriate use.
The devices must be equipped exclusively with genuine accessories. Flexiheat will not be held responsible
for any damage whatsoever arising from the use of an accessory which is inappropriate to the device.
Flexiheat is responsible for the conformity of the device to the rules, directives and standards of
construction in force at the time of marketing. The knowledge and compliance with the legal provisions and
standards inherent to the location, installation, commissioning and maintenance are the sole responsibility
of the design office, the installer or user.
