1
3
2
Signal Output
Status Indicator
Power input
The Juno™Series Smartphone RGB LED control-
lers are designed to drive constant voltage RGB
output strip lights running on 6-24VDC. It allows
you to control your LED strip lights from your
smartphone via a Bluetooth connection. Simply
download and connect the ‘ColorEasy3 Plus’ app
on iOS or Android smartphones to control your
lights. Static colors or dynamic modes can be
conveniently chosen from a smartphone. The
included RF remote control can be used for easy
power on/off and choosing previously saved RGB
settings in the smartphone app. With a PWM
frequency of 8KHz, it is flicker free for video and
photography uses.
FF-JUN-APP-RGB-COMBO
Introduction
Installation
Juno™ RGB LED
Smartphone Controller
• Auto Circuit Protection
• Support iOS & Android
• Bluetooth Connection
• Waterproof
• Ultra-Slim Design
• High Power Output
• RF Remote Included
• 6-24V Voltage Range
Bluetooth Controlled with additional RF Remotes
2. Connecting the Receiver to your Lights
This bluetooth controller is only compatible with
constant voltage LED products. The black wire on
the output side is the DC + and must be connect-
ed to the positive (+) channel on the strip light.
The green, red, and blue wires connect to their
corresponding color channels on the LED strip.
Securely connect all the wires as instructed and
double check that the polarities are matching
before turning on the power.
Tip when using solderless connectors with your
RGB strips
:
Follow the indicated channel markings
printed on the LED strip to the connected wires to
verify which wire correlates to the respective R,
G, B, and + channels.
3. Status Indicator Light
The full color status indicator displays all working
states of the controller indicating different events
as follows:
Blue fast flash:
Starting up.
Blue/yellow fast flash:
Waiting for bluetooth
pairing.
This bluetooth RGB LED controller can run on
6-24VDC. The red input power wire should be
1. DC Power Input
Operation
• The Juno™ RGB LED Controller connects to the
smartphone app via bluetooth. Scan the QR code
on this sheet to find the app in the store and
download it to your phone. You must pair your
smartphone to the app to control your lights.
• Once the receiver is powered on, the controller
will enter pairing mode for 90 seconds and the
indicator will flash blue and yellow. During this
period, you can search for bluetooth devices on
the smartphone bluetooth setting page. Connect
to ‘LED-XXX’; the X is the serial number of the
controller. The unpaired smartphone can only
discover a controller in this 90-second period. To
enter the pairing mode again, the controller must
be turned off and turned back on again.
1. Bluetooth Pairing
connected to the power supply's DC positive
channel and the black input wire to DC negative.
Be sure the power supply voltage is the same as
the LED load voltage and the power is large
enough for the wattage load.
Blue with short yellow flash:
Bluetooth connected.
Steady blue:
Bluetooth disconnected.
White flash 3 times:
New RF remote paired.
Short single white flash:
New command received.
Red flash:
Overload short circuit.
Yellow flash:
Overheat short circuit.
User’s Manual
Juno™ Series
