●
●
●
●
●
●
●
●
●
7 Use
7.1 Putting into service
Putting the machine into service is carried out upon completion of installation operations and in practice consists of the first
start-up.
Follow the procedure below to put into service:
Make the electrical connection (see par. 5.6.1).
Set the main electrical switch to position 1 or ON (see par. 6.2).
Reset any emergency buttons activated (see par. 6.5).
Press the safety reset button.
7.2 Starting processing
Perform the following operations to start processing:
If the rollers need to be heated, choose the type of roller heating. See par. 7.10 and 7.11
Check the laminating speed set on the potentiometer located on the control panel.
Verify that the parameters set correspond exactly to the processing that must be performed.
Load the material to be processed into the machine.
Press the roller rotation start button to begin processing. See par. 6.3.
7.3 Cycle pause
Warning
Remove any equipment, materials or objects used for
installation or other from the machine.
The presence of equipment or parts not belonging to the
machine can cause damage to people or to the machine
itself.
At this point, the machine is ready to start working or it can be switched off.
To start working, see par. 7.2.
Roller rotation deactivation
Press this button to deactivate roller rotation.
Roller rotation stops also by completely turning the roller speed adjustment knob in the counter-
clockwise direction, beyond zero (you will hear a “click”).
GALAXY
USE AND MAINTENANCE MANUAL
EN
MANUAL CODE: 756100330_EN
REVISION: 0
DATE: 07/03/2019
FLEXA S.r.l. - Partial or whole reproduction prohibited without authorisation
43
Summary of Contents for CWT GALAXY
Page 2: ......
Page 93: ......
Page 94: ...FLEXA Sr l reserves the right to make technical changes to this manual without prior notice...