Flex 1286016, User Manual

Page: 8 / 20

Test Board User Guide BMR4742001
28701-ROA1286016 Rev A 2021/4/25 8 (20)
•
Make sure Enable switch is set to OFF position
•
By default, the module is configured to set Vout with pin-strap resistors.
Make sure jumper in the position 10 is populated with desired Vout.
•
Connect power supply to connectors on position 1.
•
Connect load to connectors on position 2.
•
Connect the PMBus adapter/cable to the board.
• Apply Vin = 6-15V through connectors on position 1.
•
Set Enable switch to ON position.
The power good LED will give green
light.
Note: PG LED is powered by USB-PMBus adapter, so only connect demo
board with computer through adapter, LED will be lit when module Vout is
ready.
• Then increase the load, and through K2 (position 7) to measure the Vout
and ripple.
4.2 Power-down instruction
•
Set Enable switch to OFF position
•
Turn off Vin
Model Iout max Switching frequency Vin/Vout range
BMR 474 2001
0.6V≤ Vo ≤1 .8V
Iomax=80A
1.8V < Vo ≤ 3.3V
Iomax=60A
0.6V≤ Vo ≤1 .8V
f
sw
=500kHz
1.8V < Vo ≤ 3.3V
f
sw
=800kHz
Vin =6-15 V
0.6V≤ Vo ≤ 2.5V
Vin=7.5-15V
2.5V < Vo ≤ 3.3V