Flavor Burst JBT 80FCB-2B, Equipment, Maintenance And Operations Manual

Page: 50 / 64

49
Mounting the Plastic Cable Casing
The Jumbo Touch Panel system includes a
smaller plastic cable casing to hold the Jumbo
Touch Panel’s power cord and ethernet cable.
This casing is installed on top of the freezer.
The Jumbo Touch Panel cable casing should
be installed on the same side the cable exits
the assembly.
1. Find an area on the freezer to install the
plastic casing. It should be installed on top
of the freezer and on the side where the
cables come out of the Jumbo Touch Panel.
Leave approximately 3 - 4” between the
front of the cable casing and the front edge
of the freezer. Trim the casing if necessary.
2. Clean the area where the plastic casing will
be installed.
3. Remove the protective tape from the casing
and apply the casing to the cleaned area of
the freezer.
4. Open the casing and insert the power and
ethernet cables. Close the casing to finish
the assembly.
26120
Detergent
CLEAN
Water
RINSE
DRY
26125
26126
26127