Flavor Burst CTP BASE BEV-1S, Operation Manual Supplement

Page: 28 / 32

27
Connecting the Pump Harness Cable
The Base-1S unit does not come with its own
Color Touch Panel or power source. It is
designed to connect to the electronics board of
your full Flavor Burst system and is controlled
by your existing Color Touch Panel. Since the
electronics panel is located in different areas
depending on the shape of your cabinet, follow
the instructions under the appropriate section
for your current Flavor Burst system.
For convenience, keep both your Flavor Burst
cabinet and the Base unit as close together as
possible.
Ensure the cabinet is turned off. Flip the
power-switch is in the “off” position with the “
○
”
end pressed in.
Or remove the power cord from
the cabinet.
26220
NOTE: FAILURE TO TURN OFF THE
CABINET COULD RESULT IN ELECTRICAL
SHOCK.
Connecting to a Standard Cabinet
The Electronics Board is located under the cap
of your tall, standard Flavor Burst cabinet.
1. Remove the cap of your standard Flavor
Burst cabinet.
26367
2. Remove the plug from the slotted hole of
the panel at the back of the cabinet.
26368
3. Insert the Base unit’s pump harness cable
through the slotted hole of your Flavor Burst
cabinet panel.
26369
4. Insert the pump harness cable connector
into the port on the Electronics Board
labeled “BANK B” or “PWRCONN3”.
26370
5. Wrap the open-close bushing over the
pump harness cable and snap it into the
slotted hole on the cabinet panel.
26371