Should you encounter any problems, please feel free to email me at: [email protected]
2
2 filament guide tubes,
2 spool holders.
The accessory box on top of the machine includes:
2 extruder heads,
SD card,
Bolt, Hex wrench and screws kit.
Under the build platform in the Creator X framework, there are:
2 spools of filament
Un-boxing
The Creator X was carefully packed by our staff at the FlashForge factory. Please follow the un-
boxing steps laid out below.
Handle the package and its contents with extra care; do not use any unnecessary force.
Do not remove the thin yellow film from the heating plate. It is heat resistant tape that
improves the adhesion of the extruded plastic to the plate.
Do not remove the wrapping around the nozzle. It consists of a ceramic fiber fabric and
heat-resistant tape which helps to keep the nozzle at a constant temperature.
First, put the box on the floor in a clean and flat area. Remove the top two long boxes, set them
aside and then pull out the cardboard packing that encloses the Creator X. Inside the two long boxes,
you will find a power cable, USB A to B cable, 2 filament guide tubes, and 2 spool holders.
Now you can see the top of the printer, as well as some other boxes inside it. The large box with the
black wire is the
accessory box
; this contains the
extruder(s), SD card
and other important
components. Don't remove the accessory box or its contents yet.
Note: Do not lift the box by the
black cable! Doing so could damage it.
Now take the Creator X out of the box. Gently lift and transfer the printer to your work surface. You
will find the
extruder
in the protective packaging along with the black cable, carefully remove it
and place it on your work surface.