FKI SDF-22, Instructions For Use Manual

Page: 10 / 37

9
Installation
The appliance must be connected to the mains by an authorised electrician.
The fryer must always be connected to ground. Depending on variant, the fryer should be connected to ei-
ther 400V 3N~ or 230V 3~ via an approved supply isolator. Note that each heat section requires a separate
connection.
As standard, floor models are supplied with front legs and fixed wheels at the rear. Space should be left in
front of the fryer so it can be pulled away from the wall when cleaning or performing maintenance tasks.
The fryer must be connected by an authorised electrician and connected to an RCCB circuit
breaker.
See diagram for correct connection:
WARNING: This appliance must be earthed. Failure to do so may cause electric shock and serious
injury.
The appliance must be acclimatised before use. It should therefore not be started up until eight
hours have elapsed.
The power supply must be able to be disconnected, either by unplugging or by means of a freely
accessible multi-pole switch located before the power outlet in accordance with applicable elec-
tricity regulations.
The appliance must be grounded in accordance with national safety standards
for electrical appliances.
Do not use extension cords or multi-socket outlets. After installation is completed there must be
no direct access to the electrical components. Never touch the appliance if you are wet or have
bare feet. Do not use this appliance if the power cord or plug is damaged, if the appliance is not
working properly, if it is damaged or if it has been dropped on the floor.
Any replacement of the power cord must be performed by an authorised technician to avoid the
risk of personal injury
– RISK of electric shock. Only use oil-resistant cables!