FTS-B423-3
Issue 3
：
Oct. 2013
S326 Precision Cleaver
Operating Instructions
・
Please read entire manual prior to usage.
・
This manual must be kept with the S326 Precision Cleaver.
Safety Instructions
This manual contains the complete operating and basic maintenance instructions for the S326
Precision Cleaver. Please review this manual carefully before using the S326 Precision Cleaver.
The following safety instructions must be followed whenever this product is operated, serviced, or
repaired. Failure to comply with any of these instructions or with any precaution or warning contained
in this manual is in direct violation of the standards of the design, the manufacturer, and the intended
use of the instrument. FURUKAWA ELECTRIC CO., LTD. assumes no liability for the customer’s
failure to comply with these requirements.
Safety Instructions
!
CAUTION
Failure to comply with any of the instructions, which are
indicated by this symbol, may cause serious injury or
damage to the machine.
!
ATTENTION
Failure to comply with any of the instructions, which are
indicated by this symbol, may cause the device to function
improperly and degrade the performance.
Please contact FURUKAWA ELECTRIC CO., LTD. with any questions relating to the description of this
manual.
In no case will FURUKAWA ELECTRIC CO., LTD. be liable to the buyer, for any consequential or
indirect damage which is caused by product failure, malfunction, or any other problem.
!
CAUTION
・
Avoid soaking the S326 with water. Doing so may cause malfunction.
・
Do not drop, throw, and handle it roughly. Doing so may cause machine’s malfunction.
・
Do not use in a humid, dirty, or unstable site. Doing so may cause malfunction.
・
Please be cautious when disposing of fibers from the fiber waste bin. Scattered fibers may cause
injury.
・
The fiber waste bin for loose fiber must be installed into the S326 during operation, otherwise there is
danger for loose fiber to scatter.
!
ATTENTION
・
Use an appropriate tool when loosening or tightening the set screw to fix the single fiber adapter to the
unit and gently tighten the screw.
・
Strip the fiber so that 14 to 25mm is exposed passed your aimed cleave length. This will allow the
automatic fiber waste disposal feature to work properly. For instance
：
In case of 16mm cleave length, remove the coating more than 30mm(=16+14), and less than
41mm(=16+25).
・
Please clean the fiber with alcohol after stripping the coating material before setting it on to S326.
・
Do not use Organic solvent (e.g. Acetone) to clean the rubber pads.
