F7000N Tip Alignment Device Guide
Rev. A – May 20
th
2015
Fisnar Inc. | 19C Chapin Rd. Ste. 307, Pine Brook, NJ 07058 | T: (973) 646-5044 | [email protected] |
www.fisnar.com
- Page 9 -
2). Program 0 and program 1 are using an 18 Gauge tip with the same Setup Position.
If the tip is changed to a 20 Gauge tip, as long as the tip is the same length,
To use program 0 => load program 0 => run XYZ Search.
To use program 1 => load program 1 => run XYZ Search.
3). Program 0 and program 1 are using an 18 Gauge tip with the same Setup Position.
If the tip is changed to a longer 16 Gauge tip, Base Tip Position as well as Setup alignment must be
redone to change the searching characteristics. Once Setup is completed, run XYZ Search.
To use program 0 => load program 0 => New Base Tip Position => Setup Tip Initial Position =>run XYZ
Search.
To use program 0 => load program 0 => New Base Tip Position => Setup Tip Initial Position =>run XYZ
Search.
vii.
Technical Drawing of Tip Alignment Device
