www.fi shman.com
Jack connections for Onboard Aura and
Prefi x Plus-T models
• Red wire to Tip (short terminal)
• Black wire to Switch (longest terminal)
• Shield wire to Sleeve (strain relief)
• Ring is not connected (middle terminal)
Endpin jack
Install the endpin jack per Switchjack Installation
Guide.
Mount the preamp
1. Insert the pickup in the saddle slot.
2. Carefully pull back the “trap door” on the preamp
(located next to the output cable) to expose the
terminal block.
3. Insert the hot pickup wire (inner conductor) in the
left side of the terminal block, marked “IN,” the
pickup ground wire (shield) in the right side of the
terminal block, marked “GND,” and tighten down
the screws on the top of the terminal block with a
3
⁄
32
” (2.4mm) slot head screwdriver.
4. Snap closed the trap door.
5. Angle the preamp 90° from the bezel and insert
it in the cut-out, then fasten the preamp bezel
using the four self-tapping screws and the two
plastic backing plates.
Complete the installation
Install a 9V alkaline battery.
To keep the wires inside the guitar from rattling,
secure them with the included adhesive backed
clips. Attach the wire guide clips to the side of the
instrument.
Plastic Backing Brackets
Soundboard
Self-Tapping Screws
Preamp
Control Panel
Trap Door
Pulled Back
Terminal
Block
009-087-007 Rev E 5-09
Shield to
Sleeve
Red Wire
to Tip
Black Wire
to Switch
Summary of Contents for PREFIX PLUS-T - SCHEMA
Page 1: ...www fishman com USER GUIDE PREFIX PLUS T...
Page 11: ...11...