quickly than in getting an accurate depth
reading, don't worry about moving your coil at
least "1 foot away" (as in step 1) and placing the
coil "lightly on the ground" (as in steps i and 6).
Just press the SEARCH/PINPOINT pad and zero in
on the strongest response. Also, remember that
you can pinpoint targets of any size but you can
only get accurate depth readings for coin-sized
targets.
NOTE:
For quick and accurate pinpointing of strong signals
from large or shallow targets, press and hold the
SEARCHlPINPOINT pad with the coil very close to the
approximate target area. This will `tune out" most of your
target so you will only receive a response directly over or very
nearly directly over it. You may also try reducing the sensitivity
level and/or raising the coil so you can just barely hear the
signal. For very weak signals, make sure you press the
SEARCHlPINPOINT pad with the coil completely out of the
target area. You may also try moving the coil closer to the
ground or increasing the sensitivity and volume levels.
PINPOINTING/DEPTH READING
TARGET IDENTIFICATION
Target identification with the CZ-7a Pro
is quick and easy; just keep in
mind these four rules:
1)
You must be in the Target I.D. mode. If you're
searching in Autotune, locate a target and then
switch over to target I.D. by pressing the AUTO/
I.D. touch pad.
2)
For accurate identification, the center of the
search coil must pass directly over the target.
3)
There are many good targets that are not
classified by the CZ-7a Pro. As mentioned earlier,
gold rings, for example, may fall into just about
any category except iron. Many foreign coins,
especially the newer ones, may ID. as foil or pull
AUTO
I.D.
32
