Fisher Scientific I903C, Operation Manual

Page: 13 / 56

Isotemp ULT freezers have four basic modes which allow freezer setup:
Run, Settings, Calibrate and Configuration.
Run is the default mode which the freezer will normally be in during
operation.
Settings is used to enter system set points for freezer operation.
Calibrate is used to calibrate various system parameters.
Configuration allows for custom setup of various options.
The chart below shows the selections under each of the modes.
1-6 Isotemp ULT Chest Fisher Scientific
Section 1
Installation and Start-up
RUN SETTINGS CALIBRATE CONFIGURATION
Default Mode
SYSTEM OK
Control Set Point Control Probe High Alarm Test
LINE VOLTAGE
High Alarm Set
Point Optional Sample
Probe
Low Alarm Test
COMPENSATED
VOLTAGE Low Alarm Set
Point
System Battery Test
HSHX
TEMPERATURE
Optional Back Up
System Set
Point
BUS Battery Test
Display Temperature
Clear High Stage
Alarm
Set Access Code
RS485 Address
BUS type CO
2
or LN
2
Table 1-1. Modes of Operation
Panel Keys, Display,
Indicators (cont.)